18:59:57 kernel: iwlwifi 0000:03:00.0: iwl_trans_reclaim bad state = 0
18:59:57 kernel: ieee80211 phy0: Hardware restart was requested
18:59:57 kernel: iwlwifi 0000:03:00.0: WRT: Collecting data: ini trigger 4 fired.
18:46:27 kernel: sd 2:0:0:0: [sda] Attached SCSI removable disk
18:46:27 kernel: scsi 2:0:0:0: Direct-Access     Generic  Flash Disk       8.07 PQ: 0 ANSI: 4
18:46:26 kernel: usb-storage 1-3:1.0: USB Mass Storage device detected
18:46:26 kernel: usb 1-3: SerialNumber: 21D3391F
18:18:57 kernel: ieee80211 phy0: Hardware restart was requested
18:18:57 kernel: iwlwifi 0000:03:00.0: WRT: Collecting data: ini trigger 4 fired.
18:04:38 kernel: r8169 0000:02:00.0 enp2s0: Link is Down
18:04:38 kernel: snd_hda_codec_realtek hdaudioC0D0:      Internal Mic=0x12
18:04:38 kernel: hid-multitouch 0018:06CB:CD3F.0001: input,hidraw0: I2C HID v1.00 Mouse [SYNA7DA1:00 06CB:CD3F] on i2c-SYNA7DA1:00
18:04:38 kernel: Generic FE-GE Realtek PHY r8169-0-200:00: attached PHY driver (mii_bus:phy_addr=r8169-0-200:00, irq=MAC)
18:04:38 kernel: snd_hda_intel 0000:00:0e.0: bound 0000:00:02.0 (ops i915_audio_component_bind_ops [i915])
18:04:38 kernel: iwlwifi 0000:03:00.0 wlp3s0: renamed from wlan0
18:04:38 kernel: hid-generic 0018:06CB:CD3F.0001: input,hidraw0: I2C HID v1.00 Mouse [SYNA7DA1:00 06CB:CD3F] on i2c-SYNA7DA1:00
18:04:38 kernel: thermal thermal_zone5: failed to read out thermal zone (-61)
18:04:38 kernel: ieee80211 phy0: Selected rate control algorithm 'iwl-mvm-rs'
18:04:38 kernel: mei_hdcp 0000:00:0f.0-b638ab7e-94e2-4ea2-a552-d1c54b627f04: bound 0000:00:02.0 (ops i915_hdcp_component_ops [i915])
18:04:38 kernel: r8169 0000:02:00.0 enp2s0: renamed from eth0
18:04:38 kernel: iwlwifi 0000:03:00.0: base HW address: fc:44:82:ff:74:c2
18:04:38 kernel: proc_thermal 0000:00:00.1: Creating sysfs group for PROC_THERMAL_PCI
18:04:38 kernel: i2c i2c-6: 1/1 memory slots populated (from DMI)
18:04:38 kernel: i801_smbus 0000:00:1f.1: SMBus using PCI interrupt
18:04:38 kernel: idma64 idma64.1: Found Intel integrated DMA 64-bit
18:04:38 kernel: i2c_hid i2c-SYNA7DA1:00: supply vddl not found, using dummy regulator
18:04:38 kernel: r8169 0000:02:00.0 eth0: jumbo features [frames: 9194 bytes, tx checksumming: ko]
18:04:37 kernel: idma64 idma64.0: Found Intel integrated DMA 64-bit
18:04:37 kernel: r8169 0000:02:00.0: can't disable ASPM; OS doesn't have ASPM control
18:04:37 kernel: usb 1-8: SerialNumber: 20100201396000000
18:04:35 kernel: i915 0000:00:02.0: [drm] fb0: i915drmfb frame buffer device
18:04:35 kernel: sdhci-pci 0000:00:1c.0: SDHCI controller found [8086:31cc] (rev 6)
18:04:35 kernel: scsi host1: ahci
18:04:35 kernel: hub 2-0:1.0: 7 ports detected
18:04:35 kernel: usb usb2: SerialNumber: 0000:00:15.0
18:04:35 kernel: xhci_hcd 0000:00:15.0: Host supports USB 3.0 SuperSpeed
18:04:35 kernel: hub 1-0:1.0: 9 ports detected
18:04:35 kernel: usb usb1: SerialNumber: 0000:00:15.0
18:04:35 kernel: ahci 0000:00:12.0: flags: 64bit ncq sntf pm clo only pmp pio slum part deso sadm sds apst 
18:04:35 kernel: xhci_hcd 0000:00:15.0: hcc params 0x200077c1 hci version 0x100 quirks 0x0000000000009810
18:04:35 kernel: platform eisa.0: EISA: Detected 0 cards
18:04:35 kernel: rtc_cmos 00:03: alarms up to one month, y3k, 242 bytes nvram, hpet irqs
18:04:35 kernel: tpm_tis MSFT0101:00: 2.0 TPM (device-id 0xFC, rev-id 1)
18:04:35 kernel: thermal LNXTHERM:00: registered as thermal_zone0
18:04:35 kernel: pcieport 0000:00:13.3: PME: Signaling with IRQ 124
18:04:35 kernel: pci 0000:00:02.0: Video device with shadowed ROM at [mem 0x000c0000-0x000dffff]
18:04:35 kernel: pci_bus 0000:03: resource 1 [mem 0xa1100000-0xa11fffff]
18:04:35 kernel: pci 0000:00:13.3:   bridge window [mem 0xa1100000-0xa11fffff]
18:04:35 kernel: pnp 00:03: Plug and Play ACPI device, IDs PNP0b00 (active)
18:04:35 kernel: system 00:02: Plug and Play ACPI device, IDs PNP0c02 (active)
18:04:35 kernel: pnp 00:01: Plug and Play ACPI device, IDs PNP0303 (active)